Hardware Calculator
What's New
Links

Shopping: 
Roman Shade Hardware & More

Use our Hardware Calculator to determine the number of Knot Screws required for your Top-Down/Bottom-Up shade or Top-Down Only Roman shade. 

Free instructions on how to make your own Roman shade are available in the How To Section. 

You may request a sample of this item. This item does not qualify for quantity discounts because it is so tedious to count.

You want to use the smallest size screw eye possible so that it stops the knot you tie in all of the cords used to operate a Top-Down/Bottom-Up shade. Since a Top-Down shade is suspended from the mounting board by means of the cords (rather than attached to the board for a Classic Roman Shade), these knot screw eyes are essential to prevent the shade from falling on the floor!

Don't confuse these micro-screws with the screw eyes used at the top of the shade (instead of a flat pulley). The larger screw eye [Item SEM] is used as an inexpensive (but inferior) replacement for a flat pulley [Item PF]. The smaller screw eye [Item KS] is used on a Top-Down shade.  

Use the Hardware Calculator to determine the number of knot screw eyes you need:
    Top-Down/Bottom-Up shade: two (one for each side of the board)
    Top-Down Only shade: one

If you are using Cord Locks, you do NOT need Knot Screw Eyes.

Back to Shopping for Top-Down Hardware.

Contact Information:
Terrell Designs, owned by Terrell Sundermann 
5325 Sanford Cir. E. Englewood, Colorado 80113
Phone: (303) 758-0188  Email: